General Lee Conversion
The conversion of this radio is simple. Remove the four 100 Ohm resistors from the solder side of the main
circuit board. Be careful where the four resistors are soldered together. Use a minimum amount of heat and
remove the resistors strait up, otherwise you may damage the trace that they are connected to. In addition,
the traces in this area are very close and could be bridged very easily. Check your work before testing it
out, then test it and compare it to the road map.
General Lee Solder Side Of Circuit Board
General Lee 100 Ohm Resistor Closeup
Bob F
© CB World Informer Network 1996 - 2023 Worldwide Rights Reserved
October
2001Web
Edition